Parameter :

Description:

• When picture size more than printer printing width, need to split the picture to some part, and then weld them together after print out. Usually use 502 glue to joint them by hand, but this way is disadvantageous, like: slowly, after long time the glue is not hard, the glue will dirty picture, work by hand hard to control the quality etc.
• Our banner welder can resolve the problem successfully!
• Our machine no need glue, use hot air to melt the material and joint them together; it can move itself in work; with sensor in the welder nozzle, can control the work temperature accurately; is using advanced hot air heating technology, intelligent electronic temperature control and speed control system, according to the thickness of the welding material different, by increasing or decreasing the counterweight to adjust the welding pressure, so as to effectively ensure uniform welding, high-strength, tear, no leakage.

Feature:

1. Small in volume, portable and conveniently transport.
2. Automatically self-moving, adjustable speed as your requirements.
3. High welding speed.
4. Constructed simply, easy to maintain.
5. Easy to operate.
6. Digital display for controlling temperature and speed.

Application:

• Automatic"Hot Air banner Welder" is designed to weld printing cloth, PVC, tent, tarpaulin and other plastic materials, without glue. It is professionally used for PVC fabric, PE Canvas, outdoor poster banner, Plastic surface, Sailcloth...etc. Also can be used for an advertisement for booth or in house poster for own shop.

Packaging List：

1. banner welder machine
2. 1 pc brush
3. 1 set of tool
4. Instruction manual

Operation

1. Make the cloth for seaming flat and put it underneath. Fix both ends by adhesive tape or something else.
2. The overlap width of the two pieces is about 3-mm, the width of the nozzle of hot seaming machine.
3. Put the machine nozzle between two overlap pieces. The press-wheel should be at left side of nozzle. The nozzle also need align with side of upper piece of cloth.
4. Switch on the motor power and then adjust speed.
5. Turn on the movement switch.
6. Press heating power key to adjust temperature.
7. Turn the bar by anticlockwise to fix the position to start up automatic movement. The machine will go along with the overlap path by itself.
8. Turn the bar by clockwise to cease the automatic work.
9. The operator should control the moving direction and make sure the nozzle connect both with upper and under piece of cloth.

Notice:

1. During operating, if the surface cloth is dissolved and scorched or the cloth are not sticked together, please stop to adjust the temperature or speed.
2. During operating,if the seaming part is not in right position, please stop to adjust fixing position.
3. During operating, make sure clothes are flat so that stick together smoothly.
4. The hot wind of heater cannot touch the press-wheel or the rubber of press-wheel is easy to be burned down.
5. Adjust temperature to zero before turn off the heater.Switch off after 5-10 minutes.

Maintenance:

• Take care the nozzle. Use brush to clean if there is dust or block in the nozzle or filter.